![]() ![]() Use a soft brush (non abrasive) or cloth and a mild household detergent solution to remove dust, salt and other deposits.Carefully remove any loose deposits with a wet sponge.However, in areas where pollutants are more prevalent, especially in coastal or industrial regions, cleaning should be carried out every two to three months. Cleaning Powder CoatingsĮvery six months, powder coated surfaces should be cleaned to protect the finish. NB : The lock assembly has been lubricated for life, and should not be disassembled by the user. Confirm that the lock bolt or beak engages easily with the strike/catch plate when the door is closed and the lever or key is turned – adjust the door if necessary.Īnnually check that when the door is closed, the lock can be locked by key and by the lever. If removal is delayed and scraping becomes necessary the surface finish may suffer.Īnnually inspect the door to confirm that the door operates with the correct clearances, closes and opens without obstruction. ![]() Remove wet plaster, cement, mortar and other droppings immediately, using ample clean water and a sponge or rag, to avoid permanent staining or scratching of the product finish.Do not paint the lock body or faceplate.The door is protected from building fall-out such as wet plaster, mortar, paint and welding splatter.The lock engages the strike/catch plate correctly.The door is correctly adjusted with the correct clearances.The fixing screws do not damage the product finish.Īfter installation of the door ensure that:.No metal swarf or other contaminants enter the lock body.Doors stored on site are stored in a clean dry area free from cement, lime, paint, acid etc.The product must be installed according to the instructions included in the product packaging and the door should be apertured according to the door “cut-out” dimensions and tolerances shown. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |